Changing the clutch in your Ford Ranger is fairly easy and takes about two hours. Your Ranger’s clutch ought to be changed each ninety,000 to one hundred,000 miles, sooner if it the clutch plate shows wear or fails. A new clutch for a Ranger typically costs $a hundred to $200, depending on the brand.

Ford Ranger Clutch Removal Instructions

1. Remove the outside components, together with the ground shifter inside the cab of your Ranger.
2. Disconnect the exhaust pipe.
3. Take away the interior elements–the elements under the hood. This consists of the starter, which is attached to the transmission bell-housing.
4. Disconnect the drive-shaft and the hose for the hydraulic slave cylinder.
5. Use a jack to raise one side of your truck.
6. Utilizing a metric socket set, undo the transmission cross-member and bolts, which is able to help you remove the transmission from your Ranger.
7. Take away the strain plate and the worn clutch disk.
8. Inspect the clutch flywheel. If the flywheel exhibits significant quantities of wear or is damaged in any method, it is best to replace it.

Ford Ranger Clutch Installation Instructions

1. Set up your new clutch disk and stress plate using a clutch-alignment tool.
2. Put the transmission back into your Ranger, and reconnect the cross-member and all associated bolts.
3. Reconnect all inside elements under the hood, including the starter, drive-shaft and the hose for the hydraulic slave cylinder. Be sure to bleed the slave cylinder whenever you reconnect the hose.
4. Reconnect the exhaust pipe and re-install the shifter contained in the cab.
5. Drive your Ranger slowly in a managed environment, reminiscent of a parking zone, to verify the new clutch is installed properly and is in good working condition.